HUIXIN SUPPORT

————————–

TECHNICAL SUPPORT& SERVICE 

OPERATION ADVICE

FAQs

HUIXIN SUPPORT / OPERATION ADVICE

RWheel speed:

The speed at which the wheel is run affects product finish, rate of cut, and wheel life. Fast wheel speed, in general, gives harder action and a finer finish; slower speeds give softer action and a coarser finish. Following are recommended operating speeds for the most common applications.

• Cleaning and upgrading of surface conditions 10-25 m/sec

• Cut buffing on metal surfaces 30-40m/sec

• Deburring 30-40 m/sec

• Decorative finishing 10-15 m/sec

• Oxide removal 25-32.5 m/sec

Pressure:

Light to medium pressure is recommended for most operations. Flap wheels require much lighter pressure to perform properly than other non-woven wheels; unified wheels can withstand much higher pressures in order to perform deburring jobs. In all cases, avoid excessive pressure, which may result in wheel deformation and damage to the work surface.

Feed speed:

Feed speeds directly affect the number of pieces completed over a given time period. Slow feed speed reduces the number of completed pieces, while producing a shorter scratch pattern. Slow feed speed also allows for longer dwell time and permits more work to be done on each piece.

RWheel speed:

The speed at which the wheel is run affects product finish, rate of cut, and wheel life. Fast wheel speed, in general, gives harder action and a finer finish; slower speeds give softer action and a coarser finish. Following are recommended operating speeds for the most common applications.

• Cleaning and upgrading of surface conditions 2200 – 6000 RPM

• Cut buffing on metal surfaces 6500 – 8000 RPM

• Deburring 5500 – 8000 RPM 

• Decorative finishing 500 – 3000 RPM

• Imparting decorative finishes 900 – 3000 RPM

• Oxide removal 3500 – 6500 RPM

Pressure:

Light to medium pressure is recommended for most operations. Flap wheels require much lighter pressure to perform properly than other non-woven wheels; unified wheels can withstand much higher pressures in order to perform deburring jobs. In all cases, avoid excessive pressure, which may result in wheel deformation and damage to the work surface.

Feed speed:

Feed speeds directly affect the number of pieces completed over a given time period. Slow feed speed reduces the number of completed pieces, while producing a shorter scratch pattern. Slow feed speed also allows for longer dwell time and permits more work to be done on each piece.

CONTACT 

————————–

HUIXIN ABRASIVES

Ms.Ellen(sales manager)

Mobile +86 15088227166
Fax +86 579 87215927
Ellen@hx-abrasives.com
Qingxi Industrial District, Yongkang, Zhejiang Province, China

HUIXIN ABRASIVES

35# Qingliu Rd, Qingxi Industrial District, Yongkang, Zhejiang Province, China
Mobile +86 15088227166
Fax +86 579 87215927
Ellen@hx-abrasives.com
Web:www.hx-abrasives.com
Ali Web:ykyzhx.1688.com

Copyright © 2016-2019 都澜网络工作室.  Designed by DULINE.